5 resultados para Blooms

em eResearch Archive - Queensland Department of Agriculture; Fisheries and Forestry


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Harmful algal blooms (HABs) are truly global marine phenomena of increasing significance. Some HAB occurrences are different to observe because of their high spatial and temporal variability and their advection, once formed, by surface currents. A serious HAB occurred in the Bohai Sea during autumn 1998, causing the largest fisheries economic loss. The present study analyzes the formation, distribution, and advection of HAB using satellite SeaWiFS ocean color data and other oceanographic data. The results show that the bloom originated in the western coastal waters of the Bohai Sea in early September, and developed southeastward when sea surface temperature (SST) increased to 25-26 °C. The bloom with a high Chl-a concentration (6.5 mg m-3) in center portion covered an area of 60 × 65 km2. At the end of September, the bloom decayed when SST decreased to 22-23 °C. The HAB may have been initiated by a combination of the river discharge nutrients in the west coastal waters and the increase of SST; afterwards it may have been transported eastward by the local circulation that was enhanced by northwesterly winds in late September and early October.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

To experimentally investigate the effect of vertical artificial substrate and different densities of the banana prawn Penaeus (Fenneropenaeus) merguiensis on nutrient levels in prawn pond effluent, a time series experiment was conducted in a replicated tank system supplied periodically with discharge from a prawn production pond. Few differences (P>0.05) were detected between tanks without prawns, and tanks with low densities (5 prawns in 1700 litres) of prawns (10-12 g), in terms of nitrogen and phosphorus in the water column over the 28-day experimental period. Higher densities of prawns (starting at 25 or 50 per tank) caused an elevation of these macronutrients in the water column. This was partly due to prawn biomass losses from mortalities and weight reductions in the tank system. The survival and condition of prawns was significantly (P<0.05) reduced in tanks at these higher densities. The presence of artificial substrate (2 m2 tank-1) did not affect (P>0.05) the levels of nutrients in tank water columns, but significantly (P<0.05) increased the amount of nitrogen in tank residues left at the end of the trial when no prawns were present. The prawns had obviously been grazing on surfaces inside the tanks, and their swimming actions appeared to keep light particulate matter in suspension. Higher prawn densities increased microalgal blooms, which presumably kept ammonia levels low, and it is suggested that this association may provide the means for improved remediation of prawn farm effluent in the future.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

To experimentally investigate the effect of the “SKIM” mechanical foam fractionator on suspended material and the nutrient levels in prawn farm effluent, a series of standardised short-term treatments were applied to various effluent types in a static 10,000-litre water body. Prawn pond effluents were characterised by watercolour and dominance of phytoplankton species. Three effluent types were tested, namely 1) particulate-rich effluent with little apparent phytoplankton, 2) green mircoalgal bloom predominately made up of single celled phytoplankton, and 3) brown microalgal bloom with higher prevalence of diatoms. The effluent types were similar (P>0.05) in non-volatile particulate material, and nitrate/nitrite but varied from each other in the following ways: 1) The particulate-rich effluents were lower (P<0.05) in volatile solids (compared to brown blooms), total Kjeldahl nitrogen, dissolved organic nitrogen, dissolved organic phosphorus and chlorophyll a (compared to both green and brown blooms). 2) The brown blooms were higher (P<0.05) in ammonia (compared to green blooms), total nitrogen and total phosphorus (compared to both green and particulate-rich effluent), but were lower (P<0.05) in inorganic phosphorus (compared to both green and particulate-rich effluent). 3) The green blooms were higher (P<0.05) in dissolved (both organic and inorganic) phosphorus (compared to both brown and particulate-rich effluents). Although the effluent types varied significantly in these aspects the effect of the Skim treatment was similar for all parameters measured except total phosphorus. Bloom type and Skim-treatment period significantly (P<0.05) affected total Kjeldahl phosphorus concentrations. For all effluent types there was a continuous significant reduction (P<0.05) in total Kjeldahl phosphorus during the initial 6-hour treatment period. Levels of total suspended solids and volatile suspended solids in all effluent types were significantly (P<0.05) reduced in the first 2 hours but not thereafter. Non-volatile suspended solids were also significantly (P<0.05) reduced in the first 2 hours (30 to 40 % reduction) and a further 40% reduction occurred in the particulate-rich effluent over the next 2 hours. Mean values for total ammonia, dissolved organic nitrogen, total Kjeldahl nitrogen, total nitrogen, chlorophyll a and dissolved organic or inorganic phosphorus levels were not significantly (P>0.05) affected by the Skim unit in any bloom type during the initial 6 hours of testing. Nevertheless, non-significant nitrogen reductions did occur. Foam production by the Skim unit varied with different blooms, resulting in different concentrate volumes and different end points for separate experiments. Concentrate volumes were generally high for the particulate-rich and green blooms (175 – 370 litres) and low for the brown blooms (25 – 80 litres). This was due to the low tendency of the brown bloom to produce foam. This generated higher nutrient concentrations in the associated condensed foam, but may have limited the treatment efficiency. The results suggest that in this application, the Skim unit did not remove micro-algae as effectively as was anticipated. However, it was effective at removing other suspended solids. Considering these attributes and the other uses of this machinery documented by the manufactures, the unit’s oxygenation mixing capacities coupled with inorganic solids removal may provide a suitable mechanism for construction of a continuously mixed bioreactor that utilises the filtration and profit making abilities of bivalves.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fish collected after a mass mortality at an artificial lake in south-east Queensland, Australia, were examined for the presence of nodularin as the lake had earlier been affected by a Nodularia bloom. Methanol extracts of muscle, liver, peritoneal and stomach contents were analysed by HPLC and tandem mass spectrometry; histological examination was conducted on livers from captured mullet. Livers of sea mullet (Mugil cephalus) involved in the fish kill contained high concentrations of nodularin (median 43.6 mg/kg, range 40.8-47.8 mg/kg dry weight; n = 3) and the toxin was also present in muscle tissue (median 44.0 mu g/kg, range 32.3-56.8 mu g/kg dry weight). Livers of fish occupying higher trophic levels accumulated much lower concentrations. Mullet captured from the lake 10 months later were also found to have high hepatic nodularin levels. DNA sequencing of mullet specimens revealed two species inhabiting the study lake: M. cephalus and an unidentified mugilid. The two mullet species appear to differ in their exposure and/or uptake of nodularin, with M. cephalus demonstrating higher tissue concentrations. The feeding ecology of mullet would appear to explain the unusual capacity of these fish to concentrate nodularin in their livers; these findings may have public health implications for mullet fisheries and aquaculture production where toxic cyanobacteria blooms affect source waters. This report incorporates a systematic review of the literature on nodularin measured in edible fish, shellfish and crustaceans.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

This manual consists of written descriptions of jungle perch Kuhlia rupestris production and video material to demonstrate each of the key production steps. Video links are at the end of each major written section in the document. To activate the link use ctrl click. The videos enhance the instructive ability of this manual. The keys to producing jungle perch are:  maintaining broodstock in freshwater or low salinity water less than 5 ppt  spawning fish in full seawater at 28C  incubating eggs in full seawater. Salinities must not be less than 32 ppt  ensuring that first feed jungle perch larvae have an adequate supply of copepod nauplii  rearing larvae in full seawater under bright light  use of gentle aeration in tanks  postponing spawns until adequate densities of copepod nauplii are present in ponds  sustaining copepod blooms in ponds for at least 20 days  avoiding use of paddlewheels in ponds  supplementary feeding with Artemia salina and weaning diets from 20 days after hatch  harvesting of fingerlings or fry after they are 25-30 mm in length (50 to 60 days post hatch)  covering tanks of fingerlings with 5 mm mesh and submerging freshwater inlets to prevent jumping.